Boost Tracer Especificações descarregar pdf (Página 10)

Connect load positive (+) and negative (-) to the TRACER load output as shown

in figure 3-2.

An in-line fuse holder should be wired in series in the load positive (+) or

negative (-) wire as shown. DO NOT INSERT A FUSE AT THIS TIME.

If wiring the load connection to a load distribution panel, each load circuit should

be fused separately. The total load draw should not exceed the 10A load rating.

Step 2: Battery Wiring

WARNING: Risk of explosion or fire! Never short circuit battery positive (+)

and negative (-) or cables

Figure 3-3 Battery wiring

Before connecting the battery, measure the battery voltage. It must be over 9 V to

power the controller. For 24V, the voltage must be greater than 18V to properly detect

a 24V battery. The 12/24V battery detection is automatic and the check is only

performed at start-up.

Wire an in-line fuse holder no more than 150mm from the battery positive

terminal. DO NOT INSERT FUSE AT THIS TIME.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Sem comentários

Boost Tracer Especificações Página 10